Lift worm gearbox — Kharkov – Lift 4

← Full catalogue

PRODUCTION CASE|LIFT OPERATIONS|WORM GEARBOX

RESTORATION REPAIR REPORT FOR A GEARBOX

Lift worm gearbox: a worn gear pair returned to service without replacement

«Kharkov – Lift 4»  ·  restoration repair and measurements performed by the plant's mechanical service  ·  report approved by the head of the enterprise, signature and stamp

Kharkov, Ukraine  ·  report dated 12.10.2003 · repeat measurement after 400 h of operation in regular service

PRODUCTXADO technologyrestoration repair performed with the lift in regular service
TREATED UNITSingle-stage worm gearbox of a liftworm — wheel drive; worm wheel rim made of bronze
DOCUMENT TYPEReport of the enterprise
«Kharkov – Lift 4»

Key result

22.2%
worm backlash in mesh, 36° → 28°
UNITCONDITION BEFORE TREATMENTWHAT WAS MEASURED
Single-stage worm gearbox of a liftWear of the worm — wheel drive 100 %; pitting and cavities on the wheel and the wormWorm backlash in mesh; condition of the working surfaces

Worm gear pair: before treatment and after 400 hours of operation

PARAMETERBEFORE TREATMENTAFTER 400 H OF OPERATION
Worm backlash in mesh36°28°
Working surfaces of the worm wheel rim and the wormPitting and cavitiesAppearance of a smooth ground surface, cavities and pitting gone

Measurements were taken by the mechanical service before treatment and after 400 h of lift operation in regular service; surface condition was assessed by visual inspection.

Conclusion of the report

Before the work began, the worm — wheel drive of the worm gearbox had 100 % wear, the worm backlash in mesh was 36°, and there were pitting and cavities on the wheel and the worm. After the restoration repair using XADO technology and 400 hours of operation in regular service, the enterprise recorded in the report: «the worm backlash in mesh became 28°, the working surfaces of the worm wheel rim and of the worm took on the appearance of a smooth ground surface ,i.e. the cavities and pitting disappeared, the noise during gearbox operation decreased». The bronze rim, which had fully exhausted its service life, stayed in operation: the mesh was restored on a working lift, without replacing the worm gear pair.

The results relate to a single-stage worm gearbox of a lift with a bronze wheel rim, treated with XADO technology under regular operating conditions; under other conditions the figures may differ. The original report with signature and stamp is published in full and available for download.

Current equivalent

How such units are treated: Reduction gearboxGear drive

← Full catalogue