TECHNICAL ACT|BUILDING MATERIALS|BEARINGS · CLEARANCES
TREATMENT ACT FOR BEARING No. 180604
Bearing 180604: a worn unit restored, not replaced
PRODUCTXADO technologycontract No. 191 of 26.02.1999
TREATED UNITRolling bearing No. 180604radial and axial clearance measured before and after treatment
DOCUMENT TYPEAct of the customer and the contractor
with signatures and seals
with signatures and seals
Key results
↓8.3×
radial clearance of the bearing, 0.25 → 0.03 mm
↓5×
axial clearance of the bearing, 0.1 → 0.02 mm
| UNIT | CONDITION AT START OF WORK | WHAT WAS MEASURED |
|---|---|---|
| Rolling bearing No. 180604 | radial clearance 0.25 mm, axial clearance 0.1 mm | radial and axial clearance before and after treatment |
Bearing clearances before and after treatment
| PARAMETER | BEFORE TREATMENT | AFTER TREATMENT | CHANGE |
|---|---|---|---|
| Radial clearance | 0.25 mm | 0.03 mm | smaller by 0.22 mm · 8.3× |
| Axial clearance | 0.1 mm | 0.02 mm | smaller by 0.08 mm · 5× |
A reduced clearance means that metal has built up on the raceways — exactly where it had been worn away.
What this means
Bearing No. 180604 came in for treatment with a radial clearance of 0.25 mm and an axial clearance of 0.1 mm: for a rolling bearing this is wear, not a factory tolerance. After treatment with XADO technology the act records 0.03 mm and 0.02 mm on that same bearing — the clearance was closed not by fitting a new part, but by metal built up on the rolling surfaces where it had been lost. This is how the revitalizant works: the coating is self-regulating under load, it grows in the worn zone and does not grow where there is no wear. For the plant this means that a worn bearing went back into service without replacement. Clearance is the source of impact loads, vibration and noise in a unit, and cutting it several times over pushes back both the overhaul of the mechanism and the downtime that comes with it.
The results relate to rolling bearing No. 180604 treated with XADO technology at «Plitochny Zavod» JSC in March 1999; on other units and under other operating conditions the figures may differ. The original act of 17.03.1999 with signatures and seals is published in full and available for download.
Current equivalent
Revitalizant gel for compressors and bearings →
Piston, screw and centrifugal compressors; rolling and sliding bearings running in an oil bath; machine-tool spindle units and slideways.
How such units are treated: